Hi everyone,
I'm new to scripting and so far it has been really overwhelming.
I want to run a tcl file using a command directive in Xcelium, and so far i've had no luck. The tcl file was initially made for modelsim so it contains commands like vlog (verilog compiling) and vsim (verilog simulation invoking) . It works fine for Modelsim as i just enter the command "do sim.tcl' and it runs smoothly. I'm yet to find alternative commands to these in Xcelium. Also, i'm not directly using a linux computer. I'm connected to the linux computer database system through the internet and i have no visuals, only the command line.
It would be really appreciated if someone can guide me. Sorry if the question is very lame.
Regards,
A