I read the article of John Brennan "A Coverage Time-Saving Tip" of 20 Nov 2015 in the Blog section and hoped to solve the problem that after design updates I do not have to fully evaluate set up the refinement files
I put the "set_refinement_resilience setting" in the .ccf files I use during regressions but this does not solve the problem that I nearly have to re-evaluate my refinement files.
So my question is what are the steps to be taken to prevent that I have to setup the excludes in my refinement files, apparently setting the "set_refinement_resilience" setting in the .ccf files is by far not enough.
Off course it is clear that the excludes connected to removed/updated code should be removed and/or updated but I hoped to see that excludes which are connected to shifted could be easily re-used.
I am using imc:
